Joined in 2023 
82 
63 About this deal
Filoform duct seals type MD are based on a specially formulated two-component expanding polyurethane resin. However, if you have any questions about which type of sealing system might be best for your particular project or specific requirements - contact one of our experts today!
Duct sealing system FiloSeal+HD is an eginnered universal solution for sealing larger heavy cables and pipes in ducts, boreholes or transit frames. CSD RISE duct seal kits comprise of 2 components, rubber insert sleeves and FIWA sealant, making the sealing system quick and easy to install. The engineering challenges inherent in designing with PU have been overcome by technological advances that allow for low-density foam products that are easy to install on-site.
It is vital, to make sure the duplex foam is wrapped around each cable, to create separation from each other and the inside of the duct.
If not, you should never use DIY expanding foam like what's shown in the image below because it is messy and can create more problems than it solves. Duct sealing system type MDII has been developed to provide an effective and simple solution for all your Gas and Watertight duct sealing requirements. In this highly complicated operation, Johnny McQuoid, SFBB programme director for BT Group highlighted the technical challenges of the roll-out.
All CSD products have beenextensively tested, not only atBeele Engineering technical laboratoriesin the Netherlands, but also by independent experts. Failure to correctly and effectively seal cable ducts can inflict catastrophic damage to LV-HV electrical distribution networks, substations and power supply. We'll start with some information about polyurethane DIY foam comparing to our MD5 Duct sealing Resin. The high quality, one component, flexible sealant “MD+” is based on a silicon compound that cures with air (Humidity). The expanding foam is an ok product for sealing small gaps, filling voids and cracks, and insulating.
PU can be used in walls, roofs, ceilings, floors and more to provide insulation and structural support. In the UK the DNO’s (Distribution Network Operator) hold a statutory requirement to prevent danger due to the influx of water, or any noxious or explosive liquid, hydrocarbon or gas from the surrounding ground into substations, street boxes and buildings. investment in fibre, upgrading and maintaining the local access network on behalf of over 450 communication providers, including other parts of BT. Industries I know of who have explicitly banned DIY foam are the water industry (the major water companies of the UK and their contractors and sub contractors) and the petrol filling station industry.
People can spend as much of 90% of their time in indoor space, and increased comfort and IAQ have proven benefits to productivity and reduced absenteeism. If there is room and the cables are de-energized, a power tool to speed the process up could be used. View below our complete ranges of Duct Sealing Products including cable transits to provide a watertight seal and defence against flood damage to low, medium and high voltage cable ducts with additional protection against harmful flammable gas migration and fire spread.
Great Deal 
New Comment