Joined in 2023 
82 
63 About this deal
When not in use, this appliance should be stored in a safe, dry location, out of reach of children. PEET Ultra Dryer & Deodorizer (M08O3)
Boot Dryer Shoe Dryer Comparison - Christmas 2022 Best Boot Dryer Shoe Dryer Comparison - Christmas 2022
Invert the PDM and insert the top vent caps at a downward angle into the footwear. O3 is heavier than air and will fill and treat the footwear. Odor Elimination and Sterilization: Our boot dryer not only banishes odors caused by moisture but also effectively eliminates bacteria, guaranteeing your shoes are fresh and clean for both comfort and foot health The PEET Dryer can dry footwear without damage to any type of material. Footwear and gear can be washed first, or simply dried on the PEET Dryer after wearing. Loosen the tongue and laces of the footwear and place 1 Power Cell PEET Dryer in each shoe approximately 1 inch from the toe. This will allow the warm air to more freely throughout the shoe for proper drying. Using the thumb and first finger on your dominant hand, grab the prongs. While squeezing them tightly together, grab the plug housing firmly between the thumb and first finger of your other hand. Firmly slide the housing away from the prongs.
Highest Rated in Shoe Care Kits
For smaller bladders, slide the Nosepiece off the DryPort. Press down on the trigger and slide the bladder over the DryPort, making sure that the sides of the bladder are not touching it. Release the trigger.
Dryer Comparison - October 2023 Lnideas Electric Shoe Dryer Comparison - October 2023
The drying feature will remain on the entire time it is plugged in, as indicated by the red LED ON light. Slide the HIGH/LOW selector to the desired ozone setting. In HIGH mode, ozone is generated until the PDM is turned off. In LOW mode, the PDM cycles on and off generating ozone O3 50% of the time when the PDM unit is turned on. Best for use in occupied smaller rooms. LOW MODE is recommended for routine, moderate odor and for use in smaller spaces. Hydration PEET safely and quietly dries bladders/reservoirs in 2-3 hours. SafeKeeping PEET Dryer (M10) The PEET® Dryer is designed for easy use and long service. When you follow these simple instructions and guidelines, the PEET Dryer will dry your footwear or gear safely and efficiently. Drying time depends on material and saturation. Do not place the PEET Dryer close to a second heat source, such as a furnace register. Advantage PEET Dryer (M07F) Place your footwear upside down over the Footwear DryPorts. Make sure the toe is higher than the heel so that the footwear will dry thoroughly. Loosen tongue and laces for a loose fit between the footwear and the AirChambers. This will allow air to circulate properly. If ignition doesn’t occur within 2-3 attempts, place your thumb over the large hole directly behind the retaining washer and relight. Once lit, leave your thumb over the hole until the heater warms up (about 15-30 seconds). There will be a small blue flame in the center tee. The PEET Dryer will get warm, reaching its maximum temperature in 10 minutes, but it does not get hot. This product uses natural thermal convection technology; there are no fans or moving parts, therefore it will not blow hot air or make noise. APPOINTMENT TIMING &INTELLIGENT CONSTANT TEMPERATURE, GIVE YOU PEACE OF MIND: 120-minute timing function, Automatic power-off, sleep in peace of mind get up and wear warm shoes, Constant temperature control maintains the temperature at around 107 °F ,This is the right temperature for drying, to avoid damage to the shoes due to excessive temperature, and the intelligent thermostat system can better understand the temperature of your feet.
Boot Dryer Shoe Dryer Glove Dryer Boot Warmer with Heat
The Go! PEET Dryers can safely be left plugged in and in your footwear overnight or until you are ready to wear them again, without any harm to the product. Smart Temperature Control and Timer Functionality: Equipped with a PTC heat generator, the shoe dryer precisely controls the drying temperature, maintaining it at a safe 55°C to prevent overheating and damage to your beloved footwear. Customize drying times with 4, 8, and 12-hour timer options for safety and energy efficiency Do not place the PEET Dryer close to a second heat source, such as a furnace register. Go! PEET Dryer (M04P) The Go! PEET Dryer uses Positive Temperature Coefficient (PTC) heating technology to assure safety. PCT heating elements are small ceramic stones with self-limiting temperature characteristics. PTC stones are energy efficient and have fast heating response times that plateau once the pre-defined reference temperature is reached. This technology has been installed and set to a predetermined temperature that maximizes the effectiveness of the dryer and will not allow it to overheat. Suitable for Various Footwear: The shoe dryer accommodates a wide range of shoe types, including cotton slippers, leather shoes, canvas shoes, work boots, snow boots, and sneakers. Regardless of your shoe style, it delivers outstanding drying resultsIntelligent Timer】Set different working time for different kinds of shoes (up to 99 minutes). Easy to reduce power consumption. Place the dryer in the corner of the safe or cabinet with the AirChamber in the upright position. If desired, the dryer can be mounted to the floor or base of the safe or cabinet (never to the sides or ceiling). Fasten the dryer to the base surface by securing screws in the holes on the dryer’s base into the safe’s padding (not into the metal). Route the cord through your safe wall or cabinet base. (Refer to electrical cord installation instructions below.)
Great Deal 
New Comment