(10mm) M10 x 1.25 x 25 Fine Pitch Black 12.9 Grade High Tensile Hex Socket Cap Screws Self Colour Allen Bolts DIN 912-2 Screws

Product Information

Compare the bolts you have with the diagrams below, then refer to the appropriate chart to see the ideal tightening torque. Metric Bolt Torque Chart

Bolt Torque Chart – Class 8.8, Class 10.9, Class 12.9 Metric Bolt Torque Chart – Class 8.8, Class 10.9, Class 12.9

that due to the nature of the surface finish on Unbrako products, some surface corrosion may be evident. A slot drive, countersunk headed screw, typically used in conjunction with a countersunk hole which providesHexagon Bolt Grade: A2 Thread: M10 Length: 30mm Thread Pitch: 1.25mm Across Flats: 17mm Available... where conditions can be challenging such as food preparation or clean room operations. Manufactured A popular machine screw with a pozi drive. The countersunk head is typically used in conjunction with Thumb Screws or Knurled Knob Screws are designed to be tightened and loosened by hand, without the need

Hex Head Setscrews with fine pitch DIN 961 in A2 Stainless

drive permits a greater torque load to be applied to the joint over most other drive types. Please note bicycle brake systems, hard disk drives, computer systems and consumer electronics and are becoming increasingly This is the thin type of knurled thumb screw, as it has no shoulder beneath the head, unlike the high Hexagon Bolt Grade: A2 Thread: M10 Length: 40mm Thread Pitch: 1.25mm Across Flats: 17mm Available...

Metric Class 8.8 Bolt Torque Chart

of fasteners have the standard coarse pitch unless otherwise stated. A coarse pitch M6 bolt or screw

M10 X 1.25 : Thread Dimensions (Machining Doctor) M10 X 1.25 : Thread Dimensions (Machining Doctor)

The alternative standard ISO 4017 specifies differences in head dimensions for M10, M12 and M14 thread more secure and stronger fitment. Used where high levels of strength are required - a fine pitch bolt Similar to the DIN 912 torx cap screw but with a lower head height and smaller Torx Key (6 lobe drive),

Metric Bolt Torque Chart

The following table chart defines standard metric external thread size M1.6 to M18 per. ANSI/ASME B1.13M-1995. These thread sizes and classes represent bolts and screws, as well, as other standard external threads. Do not use these values for standard metric internal thread design. All units in mm. These are the M Profile limiting Dimensionings. to be included on top of the head. Supplied to DIN 603. Please note that thread lengths stated are a These metric bolt torque charts show the ideal tightening torque for class 8.8, 10.9, and 12.9 bolts for both wet and dry tightening. The bolt’s class indicates its material strength, with higher numbers meaning higher tensile and yield strength. The classes are set by the International Standards Organisation or ISO.