DELL-UP2718Q

Product Information

x Thunderbolt 3 Downstream (DP 1.4), 2 x USB 3.2 Gen 2 Downstream, 2 x USB 3.2 Gen 1 Downstream (1 x BC 1.2 charging capability at 2A max)

Dell U2718Q Firmware Update | Driver Details | Dell US Dell U2718Q Firmware Update | Driver Details | Dell US

This is an excellent result from factory calibration. As promised, average Delta was less than 1 and Maximum Delta was less than 1.5. I tested the accuracy of sRGB and DCI-P3, which were also within the norms. Hardware Calibration via Built-in Colorimeter After I set everything up, I opened up a white document on the screen to see if there are any dead pixels – there weren’t any. With uniformity compensation turned on, brightness of the monitor looked pretty even, and I did not see any green / magenta tint issues that I have previously seen on other monitors, including the BenQ SW271. Using the OSD, I navigated to Uniformity Compensation and turned it off, then again inspected the screen. I honestly could not see much difference between the two, which is why it was more meaningful to run a DisplayCAL uniformity test to really see how even the brightness of the monitor is (further down below). Factory Calibration Accuracy Opmerking: Raadpleeg het pdf-bestand Firmware Update Instruction voor meer informatie over de stappen. USB 3.0 downstream ports (2 with fast charging), audio out, uniformity correction, hardware calibration, Owners of UP2516D-UP2718Q better stay with SDK 2.0 for they projects… if they exist, AFAIK no GNU release of custom HW calibration for these displays.From there, it was time to fire up hardware calibration using the built-in colorimeter and see how it does when compared to the i1Display Pro. This is the part I was a bit worried about, since differences in colorimeters can sometimes create issues when assessing colors. sure you do NOT want DCI-P3 as calibration target if you are asking, white point is not your typical white. I connected the monitor to my iMac Pro using the Thunderbolt 3 cable. Once attached, the monitor immediately recognized the connection and turned on. It is nice that the built-in hub provides another Thunderbolt 3 downstream port. This way, the monitor is not eating up another port on the iMac, and I can still connect other Thunderbolt 3 or USB devices to it. our response time measurement article for a full explanation of the testing methodology and reported If you have overhead or side lights in the room, it is a good idea to attach the provided monitor shading hood. The shading hood comes in a single piece with rubber dividers, making it very easy to attach to the sides of the monitor via magnets. Unlike some of the flexible plastic hoods on other monitors, this one will only work in horizontal orientation.

DELL ULTRASHARP 27 4K MONITOR | U2718Q

Wow! It looks like Dell’s hardware colorimeter is excellent – look at how well it measures with the i1Display Pro. I was skeptical about the hardware colorimeter on this monitor, but it looks like Dell did a great job with it, and it matches the best consumer-grade colorimeter on the market today! hardware aspect ratio options with 16:9, auto resize, 4:3 and 1:1 pixel mapping modes available which I selected a 5×5 grid and measured each part of the square, placing the X-Rite i1Display Pro colorimeter in the middle of each one. Below is the result, showing DeltaC deviations:Still, I decided it was a good idea to test the accuracy of the factory calibration using the X-Rite i1Display Pro colorimeter. I fired up DisplayCAL and measured Adobe RGB. Below are the results: