Compression 40mm Waste Pipe 90 Degree Bend

Product Information

For those that are new to plumbing, compression fittings provide the ideal introduction as they are easy to fit and adjust

Whether you need DZR fittings for commercial or residential construction, our collection includes adaptors, couplers, elbows, connectors, tees and stop ends designed for use in applications that deliver water consumption.Similar to our imperial fittings range, our selection of metric fittings includes elbows, olives, straight couplers, and tees to be used on LPG. Despite the above minor disadvantages, push fit plastic compression wastes do have many advantages that can be seen below:

Due to the size of pipe you are cutting (32 or 40mm), you will need to get some of the shear-type cutters.Flexible waste straight coupling allowing you to join two pipes from 38mm to 45mm and absolutely ideal in a conversion or renovation situation. This fitting is also available to convert from 30mm to 38mm and can be bought as a flexible bend from 40mm to 48mm Screw down the cap. Take your time while doing this and keep your eye on the seal and washer making sure they do not twist and that all is flush with the main body and pipe. Screw up until it starts to go tight and then give it one final pinch to create your water tight seal Open up the shears to their full width and place the pipe on the base of the jaws. It does help to rest the cutters on bench or stable surface to support them and the pipe.

At this point, position the pipe so that the top cutting jaw is directly over the mark on the pipe, or just to the side if you have marked the cut point exactly on the line. A compression straight coupling, joining two pipes of the same size in a straight line. 32mm and 40mm Tighten until the screw cap goes tight and then give it one final pinch and all should be fine. If you do find it leaks, simply screw up a little tighter. Tapered Rubber Seal: This is pretty much the core part of the system – the tapered part of the seal pushes into the gap against the main compression body which also pushes in on the pipe holding it firmly in place and creating a seal between the pipe and the compression unit body preventing any leaks A flexible fitting which will allow to you connect a 32 or 40mm pipe round a wide bend to another sized pipeCompression waste adjustable bend taking two pipes of the same size (32 or 40mm) round from a straight line up to 90 degrees. Again, invaluable in a conversion or renovation situation In most situations, you don’t need to screw the cap up too tight for it to provide enough pressure to create a seal. They are designed to be done up using hand pressure only so no grips or pliers are needed.