TP-Link JetStream 24-Port Gigabit L2 Managed Switch with 4 SFP Slots, Supports 24 Gigabit RJ45 ports, Rackmount (TL-SG3428)

Product Information

Do NOT turn off the power during the upgrade process, as it may cause permanent damage to the product. You can use the Auto-Completion feature to enter a complete command, you can also enter part of the command without completion, and the switch will recognize and execute the command automatically.

A querier periodically sends a general query on the network to solicit membership information and sends group-specific queries when it receives leave messages from hosts. It's recommended that users stop all Internet applications on the computer, or simply disconnect Internet line from the device before the upgrade. The switch supports configuring IGMP Snooping on a per-VLAN basis. After IGMP Snooping is enabled globally, you also need to enable IGMP Snooping and configure the corresponding parameters for the VLANs that the router ports and the member ports are in. The command is “ip igmp snooping vlan-config vlan-id”. Microsoft® Windows® 98SE, NT, 2000, XP, Vista™ hoặc Windows 7/8/10/11, MAC® OS, NetWare®, UNIX® hoặc Linux.

In summary, to set a port as an access port for a certain VLAN, take VLAN 100 as an example, the common configuration is: IMPORTANT: To prevent upgrade failures, please read the following before proceeding with the upgrade process After you finish the configurations, don't forget to save them, otherwise, they will be lost if you power off or reboot the switch. A firmware update can resolve issues that the previous firmware version may have and improve its current performance. To Upgrade

IGMP Snooping helps the switch maintain a multicast forwarding table by snooping the IGMP transmission between the host and the IGMP Querier. With the forwarding table, the switch can forward multicast data only to the ports that are in the corresponding multicast group, to constrain the flooding of multicast data in the Layer 2 network.Three networks with different VLAN IDs have been registered on the router and three computers should be connected to three different networks. Now we need to configure VLAN on the switch. VLAN and port configurations are listed below: Using the Omada SDN Controller to Manage Omada Devices Across Multiple Locations Via a VPN Connection (Controller 5.0 and Above) 05-05-2023 17174

After entering part of a command, you can press the TAB key or a question mark (?) then the switch will automatically complete the command. If your input corresponds to more than one command, the switch will not auto-complete but will display all related commands. What's the difference between the Master Administrator, Administrator and Viewer accounts in the Omada Controller? 04-12-2023 16282 Feature Filter: All Configuration Guide User Application Requirement Further Assistance Troubleshooting When You Set Up FAQs Note the Ethernet port type in the command is the native speed mode of the ports, not the current operating mode. For example, assuming the current speed mode of SFP+ port 25 is 1Gbps, to configure it, the command should be “interface ten-gigabitEthernet 1/0/25”, or simply “int te 1/0/25”. What's the difference between Master Administrator, Administrator and Viewer account in Omada Controller? 04-20-2023 16282Feature Filter: Tutto Configuration Guide User Application Requirement Further Assistance Troubleshooting When You Set Up FAQs