Silverline Mini Pipe Bender 6 - 10mm (MS129)

Product Information

The name Bender was chosen by creator Matt Groening as an homage to John Bender (played by Judd Nelson), a character in The Breakfast Club. In that film, John Bender told Principal Vernon ( Paul Gleason), " Eat my shorts," an eventual catchphrase for another Groening creation, Bart Simpson. [8] Rubber feet are available code 2607F which fit the 1215K, 1315XVE, 1315Longarm, 1222G, 1322Extended. Two rubber feet are included in the 22mm versions. The rubber feet also fit the Monument 15mm/22mm combi bender 2600K. The single sizes of each bender with their shorter bending arms and lightweight aluminium die casting makes each bender lighter to carry and the design of the 15mm-XV is small enough to fit inside a toolbag. better sight lines– as the bend is in the same plane as the Arms of the bender it is easier to line up by eye Place the Lever Arm over the positioned pipe and place the Lever Hook onto the Pivot Pins, ensure the Nylon Guide is seated.

Bender is powered by alcohol-based fuels, which he can convert into an electrical power source sufficient to operate not only himself, but also small household appliances plugged into his power receptacle. [24] Low alcohol intake levels decrease his production of electricity: when he stops drinking and begins to "sober", his behavior grows increasingly ebrious and dysfunctional, and he grows a red beard of rust. [25] He is also, apparently, able to sustain himself by consuming mineral oil, though he considers this to be only 'functional'.If the holes are too close to the bend, they may get deformed. Round holes are not as problematic as other types but your bolts may still not fit through. Again, see the bending force chart for minimum flange measurements and put the holes farther than the minimum. Symmetry To avoid confusion, the rectangular hole could be on both sides throating occurs on testing with the XV, XVE (XVL) XXII, XXIIE as well as Monument 2600K and a Hilmor® GLM If you use rivet nuts near the bending line, it’s known that inserting them before bending is good for securing its applicability. After bending, the holes may be deformed. Still, make sure that the nuts won’t be in the way of tools when bending. Small Flanges on Big Parts A small bend at the end of a large part may lead to difficulties

We believe the 1215K-XV, the 1315XVE, the 1315Longarm-XVL, the 1222G-XXII and the 1322Extended-XXIIE are easier to use than a combi bender:A. Pipe wall size is a lot thinner than it used to be, plus the pipe bender former could be stiff (Answered by D S plumbing and heating on 26 Jan 2021)

If there are no extra requirements from the customer, then by default ISO standard tolerances (class m) are applied to our products. Bending tolerances are shown in the table above.

Tooltalk Reviews

The 2600K includes 15mm and 22mm aluminium guides. These guides are available as spares;15mm 2601N and 22mm 2603T. These guides also fit Irwin® and Hilmor® GLM. The nylon guides are integral to the pipe bender helping to ensure they don’t get lost or damaged in a toolbag. Codes for these spare guides are 1216N 15mm Spare Nylon Guide and 1223J 22mm Spare Nylon Guide. lighter in the hand than a combi. The Monument combi weighs more than 4kg; the XV weighs 1.5kg; the XXII weighs 2.3kg The 15mm 22mm pipe bender or tube bender is an essential part of the toolkit for any heating or plumbing engineer. Cohen, David X (2003). Futurama season 1 DVD commentary for the episode "The Series Has Landed" (DVD). Los Angeles, California: 20th Century Fox.