Creality HALOT ONE Resin 3D Printer with 5.96 inches 2K Mono LCD, Intergral Light Source and Fast Printing, Precise Z-axis Module and WiFi Control, Assembled Out of The Box

Product Information

There are some factors that greatly influence your printing success no matter what material you choose. This is a crucial step, and one you shouldn't skip. Every printer is slightly different, and the settings that work on one unit might not work the same on another.

Here are some prints I made with the LD-002H, with an exposure time of 2sec per layer, and Eryone waterwashable resin.Some of you may know that the printers will release odor and impurities when printing. Creality pays a lot of attention to customers' health and user experience. The temperature of your resin should be at a minimum of 20°C when printing, and ideally over 25°C. You can either make sure your room temperature is within this range, heat the printer or pre-heat the resin before pouring it into the vat.

Here comes the good news. The new print LD-002H adopts an upgraded UV Light Source Module and an upgraded transmission system. Compared to the LD-002R resin 3d printer, it greatly improved the stability of the light source and the success rate of printing. The Creality LD-002H is an open type of 3D printer. This means it can use any brand of resin, not just the ones sold by Creality. Some settings such as support density are not included in the table, as they are heavily dependent on the 3D model. Resin 3D printing is great, with a much better print quality and level of detail than a filament FDM printer, but you will need to spend some time cleaning your parts, either with IPA alcohol, or with water if you use waterwashable resin.Below are some of the models 3D printed with the Creality LD-002H for you to see what to expect from the printer.