Danfoss 088H3220 Thermot Thermal Actuator for Underfloor Heating (10 Danfoss Actuators

Product Information

Another point is that tado wireless receiver has also the connection for a relay. I was wondering if the wireless receiver could be connected via eBus to the heating system and via the relay wires to the actuator. (If yes, then I could use a tado wireless temperature sensor in the living room and get rid of the wires. (But I do not know how to configure the wireless receiver to control both eBus and relay.) We have a new underfloor system in an open space Livingroom / Kitchen in a L-shape. The builder put 2 zones in the kitchen are ( one end of the imaginable L-shape ), one zone in the middle where the main Livingroom area is and one zone at the other end of the L-Shape area, where the dining area is, plus it goes over in a nearby small utility / toilet. ( see image )

PeterW, the Wunda self balancing actuators look very interesting. I will have this in mind, should I still need actuators. Thank you. Somehow it feels that max two Thermostats would make the most sense, and to turn the existing pump for the underfloor heating with those on or off in addition.

Danfoss Thermot thermischer Stellantrieb Fußbodenheizung 230V 088H3220 Motor

I wonder how we can control it best via Tado and how many Tado wired Thermostats are useful, as I could just install them quite close together ( like around the corner with 1 m each from the corner ), maybe with new wiring one direct in the kitchen area and one in the Livingroom/dining room area If they are using a switched live configuration then it'll be fine but if they are using a resistance based method you'll need to replace the wiring centre - which is what I had to do. JohnMo, what do you mean by " single thermostat controlling pump". At the moment I have a grundfos pump.

I wonder if I need a wiring to the boiler in the loft by using the Tado wired smart thermostat downstairs, and the wireless smmart thermostat next to the boiler? We have a new underfloor system in an open space Livingroom / Kitchen in a L-shape. The builder put 2 zones in the kitchen are ( one end of the imaginable L-shape ), one zone in the middle where the main Livingroom area is and one zone at the other end of the L-Shape area, where the dining area is, plus it goes over in a nearby small utility / toilet. ( see image ) I plan to connect the wires of the tado thermostat to a relay which could trigger the on/off of the actuator. Hopefully the tado thermostat will also "inform" (via the wireless communication) the central heating to start. I bought the wireless extension kit and I wired the wireless receiver directly to the heating system and it communicates wireless with the smart thermostats.Modellkompatibilität: 2 Watt, 230V - 2 Watt, HC-12a, 230 Volt - 2 Watt, 2 W, A+++ - D, 230V - 1 Watt, Keine I would like to turn the underfloor heating off when a max temp reached and/or over night incl. controlling the underfloor heating pump. ProDave Do I get it right that you recommend the a motorised valve to avoid the problem which I have at the moment, which is that even when I turn of the pump and the heating is on, it gets hot water pumped through by the main boiler, of course less than with the pump on.