Waveshare Ethernet Module, High-Performance 10/100 Ethernet Physical Layer Transceiver (PHY)

Product Information

Actually the board has two STM32 chips. One is the target of the demo board, and the other is the STLINK. ESD Protected MII/RMII Fast-Ethernet PHY with HP Auto-MDIX and SMSC flexPWR TM in a Small Footprint If a non-standard BootLoader has already been written to STM32, connection of nRTS pin and RESET pin is required. In the future, Ethernet support using external PHYs will change significantly and support may change.

Microchip's LAN8710A/LAN8710Aiarehigh-performance, small-footprint, low-power 10BASE-T/100BASE-TX transceivers specifically designed for today's consumer electronics, industrial and enterprise applications. The LAN8710A/LAN8710Aiarethe industry's smallest footprint solution with up to 40% lower power consumption than existing Microchip transceivers. The LAN8710A/LAN8710Ai have an integrated voltage regulator and ESD protection components to help reduce Bill of Material (BOM) costs.

Power and mode must be individually controllable. Some devices may not function properly if the mode is also turned off when the power is turned off.

Installing using the ZIP file and then updating using the Library Manager will result in duplicate libraries. my knowledge is not so deep to understand if Olimex has more feature than the proposed cheaper device EDIT: After reading that the lenght of wires can be an issue at 50MHz, I wired it with 10cm wires (instead of 20cm on the photo), still the same. Zibee add ``SetOption120 1`` or ``ZbEndpointTopic`` to add the endpoint as suffix in topic when using ``SetOption89 1``

ESD Protected MII/RMII 10/100 Ethernet Transceiver with HP Auto-MDIX Support and flexPWR짰 Technology in a Small Footprint iBeacon (xdrv_52): Clean up BLE_ESP32 based driver; add commands and advert timing. Remove HM10 code - it's in the other one..... i know that tasmota is at beta stage for esp32, and i fint this very cheap device that can support also the LAN connection When STM become officially supports external PHY Ethernet, I will delete this repository. Hardware requirements I have copy and pasted template {"NAME":"WT32-ETH01","GPIO":[1,1,1,1,1,1,0,0,1,0,1,1,3840,576,5600,0,0,0,0,5568,0,0,0,0,0,0,0,0,1,1,0,1,1,0,0,1],"FLAG":0,"BASE":1}

Add command ``L1MusicSync <0|Off>|<1|On>|<2|Toggle>, 1..10, 1..100>`` to control Sonoff L1 Music Sync mode sensitivity and speed ( arendst#10722) BLE_ESP32 (xdrv_79): Start scan as soon as we are connected to a device - saves missing a few adverts.

Parametrics

I have successfully flashed WT32-ETH01 using FT232RL FTDU module, ESP_Flasher and tasmota32-ethernet.bin (from https://github.com/tasmota/install/raw/main/firmware/unofficial/tasmota32-ethernet.bin)

ESD Protected MII/RMII 10/100 Ethernet Transceiver with HP Auto-MDIX Support and flexPWR Technology in a Small Footprint

Is it normal? Why I can't have Ethernet connection without wifi connection? Then what is the point having Ethernet connection?